Details of installation of a cable of a drive of a release of a latch of the lock of a cowl (1 of 2)
1 - Latch release lever; 2 - Bolt; 3 - Drive cable
Details of installation of a cable of a drive of a release of a latch of the lock of a cowl (2 of 2)
1. Open the hood and remove the lock assembly (see Section Removal and installation of the lock of a cowl).
2. Find the drive cable (3) on the wing mudguard.
3. Remove the cover on the left under the instrument panel (see Section Removal and installation of the lower covers of the panel of devices), - do not disconnect the electrical connector.
4. In the car, remove the screw (2) and remove the lever (1) releasing the latch of the hood lock by pulling it back while pressing it down.
5. Pulling back, retract the cable (3) complete with lever (1) into the passenger compartment, - first lubricate the rubber bushing in the bulkhead of the engine compartment.
6. Disconnect cable (3) from the lever (1).
7. Installation is carried out in reverse order - a damaged bushing in the bulkhead must be replaced.