Contents: Removal ↡ Installation ↡
Removal
1. Remove the gearbox.
2. Remove the clutch.
3. Remove the radial bearing 2 (see figure 2.60). Remove cover 3 together with bearing 2.
Figure 2.60. Crankshaft ball bearing:
1. Ring,
2. Bearing,
3. Lid,
4. Puller,
5. Auxiliary tool.
Installation
4. Installation is carried out in the reverse order of removal. Press the bearing until it stops in ring 1. Bearing 2 must sit firmly in the crankshaft hole. Press cover 3 until it stops.
Publication taken from an online resource: Mercedesman.ru