Replacing the bearing at the end of the crankshaft (Mercedes-Benz E-Class W124)

On models with a manual transmission, a bearing is installed at the end of the crankshaft on the flywheel side, on which the input shaft of the gearbox rests.

Bearing location at the end of the crankshaft

1. Remove the flywheel and clutch.

2. Remove the retaining ring and, using an inertia hammer with special grips, remove the bearing from the end of the crankshaft.

(Material taken from a web resource: MercedesMan)

3. Clean the bearing seat at the end of the crankshaft.

4. Apply a thin layer of special glue to the outer ring of the bearing.

5. Using a tubular drift resting on the outer ring of the bearing, install the bearing into the crankshaft seat until it stops and secure it with a retaining ring.

6. Install the clutch and flywheel.