Warning and indicator lights on the instrument panel
Check Engine Light (Check Engine Light)
When the electronic key in the ignition switch is turned to position 2, the indicator lamp lights up.
It goes out when the engine is running.
If the indicator lamp comes on while the engine is running, there may be a fault in the fuel injection system, ignition system or exhaust system.
Exhaust emission limits may be exceeded.
Note: Contact a service station as soon as possible "Mercedes-Benz" to check the car.
Brake system warning light
When the electronic key in the ignition switch is turned to position 2, the indicator lamp lights up.
It goes out when the engine is running.
If this indicator light comes on while the engine is running, the parking brake is not released or there is too little brake fluid in the brake reservoir due to a leak.
There is a risk of accident!
If the brake fluid level in the receiver has dropped below normal, this may lead to failure of the brake system!
Do not add brake fluid.
You cannot continue moving.
You must contact the service station "Mercedes-Benz".
SRS Safety System Warning Light (Supplemental Restraint System)
When the electronic key in the ignition switch is turned to position 1 or 2, the indicator lamp lights up for approximately 4 seconds. This confirms that the occupant restraint systems are working properly (airbags, seat belt tensioners and automatic child seat recognition system).
If it does not light up, does not go out for a long time, does not go out at all, flashes or lights up while driving, then there is a malfunction.
There is a risk of accident!
If there is a malfunction, the passenger restraint systems may not operate in an emergency situation. In extremely rare cases, the airbags or seat belt tensioners may also operate spontaneously.
Proceed with caution to the nearest service station "Mercedes-Benz"!
(Airbags, seat belt tensioners and automatic child seat recognition are discussed in Section Security systems).
Fuel reserve warning light
If the "1" warning light on the fuel gauge comes on while the engine is running, the fuel reserve has been reached.
Electronic Traction Control (ESP) Warning Light
When the electronic key in the ignition switch is turned to position 2, a warning light comes on in the speedometer. It goes out when the engine is running.
If the warning light comes on or flashes while driving, refer to the "Electronic Traction Control (ESP)" section of Section Vehicle control and auxiliary systems.
The warning light comes on or flashes while driving - refer to the subsection "Electronic traction control (ESP)" in Section Vehicle control and auxiliary systems.
Distronic (DTR) warning light
When the electronic key in the ignition switch is turned to position 2, a warning light comes on in the speedometer. It goes out when the engine is running.
If the warning light comes on while driving, refer to the "Distronic System" (DTR) subsection of Section Vehicle control and auxiliary systems.
Note: For vehicles without the "Distronic" system, the lamp has no function.
It lights up when the electronic key in the ignition switch is turned to position 2 and goes out when the engine is running.
ABS warning light
When the electronic key in the ignition switch is turned to position 2, the anti-lock braking system (ABS) indicator lamp lights up. It goes out when the engine is running.
If this warning lamp lights up while the engine is running, the ABS system has been disabled due to a malfunction. In this case, the normal braking effect of the brake system without the anti-lock function remains available.
If the ABS control unit fails, there is a risk of failure of other systems, such as the "Parktronic", navigation system and automatic transmission.
If the ABS system malfunctions, the electronic traction control system (ESP) and the brake assist system (BAS) are switched off. The warning system indicators and fault signals appear on the multi-information display.
Contact the service station "Mercedes-Benz" to check the ABS system.
Note: When the electrical voltage drops below approximately 10 V, the indicator lamp on the instrument panel also lights up and the ABS system is disabled. When the voltage rises above the specified value, the indicator lamp goes out and the ABS system is ready for operation again.
Warning and indicator lamp on the center console
AIRBAG-OFF control lamp
When you turn the ignition key to position 1 or 2, the indicator lamp comes on for approximately 6 seconds
If it does not light up, there is a malfunction.
Control lamp
Indication of warning system and fault signalling on the multi-information display
Warning system indications and fault signals for the following systems appear immediately on the multi-information display. They are divided into three categories.
Category K1: Highest priority alerts.
They cannot be activated by pressing the R button on the dashboard.
Categories K2 and K3: Medium and low priority alerts.
They can be activated by pressing the R button on the instrument panel and are then stored in the fault memory (Section Multifunctional steering wheel, multi-information display).
Note: For certain warning and malfunction signaling system indications, an additional audible signal is emitted. For red warning and malfunction signaling system indications, an audible signal is always emitted.
Warning system indications and fault signalling, such as:, "TRUNK OPEN" (THE TRUNK IS OPEN) are not recorded in the memory as fault indication.
Indicator malfunction

* K Category (see above).
If this indication appears, it is no longer possible to transmit all information from the engine control unit. It may be that the coolant temperature gauge, tachometer, system indicator are faulty "Speedtronic" or tempostat.
Indicator malfunction

* K Category (see above).
Indicators of several systems have failed. It is possible that some systems have failed as well.
Battery/Generator

* K Category (see above).
The battery is not charging.
Correct the problem immediately.
The ribbed V-belt may break. In this case, the ribbed V-belt must be replaced to continue driving. Otherwise, due to the failure of the coolant pump, overheating may occur, which will damage the engine.
Emergency Brake Assist

* K Category (see above).
If the Brake Assist System (BAS) fails, the normal braking effect of the brake system without the BAS function remains available.
Wear of brake linings

* K Category (see above).
The brake linings have reached their wear limit and must be replaced as soon as possible.
Brake fluid

* K Category (see above).
There is a risk of accident!
If the brake fluid level in the receiver has dropped below normal, this may lead to failure of the brake system!
Do not add brake fluid.
You cannot continue moving.
You must contact the service station "Mercedes-Benz".
Smart card (kEYLESS-GO system)

* K Category (see above).
1 Check the charge of the smart card batteries (Section Locks, keys and bolts. Smart card. Single lock).
2 The smart card was not recognized while the engine was running. Start searching for the smart card immediately, as it is no longer possible to lock the vehicle or start the engine after the engine is switched off.
3 Smart card was not recognized. If necessary, the car is controlled using the electronic key.
4 The smart card was recognized when locking the locks.
DISTRONIC (DTR) system

* K Category (see above).
- 1 The system is temporarily unavailable due to electromagnetic radiation.
- 2 Clean the cover of the "Distronic" system in the radiator grille (Chapter Body).
- 3 "Distronic" system defective
- 4 Systems are faulty "Speedtronic" and "Distronic".
Landing position

* K Category (see above).
Wait until the seat and steering wheel are in the driving position. After this, the indicator light goes out.
Electronic traction control system

* K Category (see above).
- 1 If the ESP system malfunctions, engine power may decrease.
- 2 The stabilising effect of the Electronic Stability Program (ESP) and the traction control system are not available.
- 3 After the power supply voltage disappears (disconnection of clamps or discharge of the battery) the system needs to be re-aligned.
To do this, turn the steering wheel from lock to lock. After this, the malfunction indicator goes out.
Parking brake

* K Category (see above).
Trunk

* K Category (see above).
Coolant (coolant level)

* K Category (see above).
(To add coolant, refer to Chapter Routine maintenance).
Coolant (coolant temperature)

* K Category (see above).
- 1 The ribbed V-belt may break. In this case, the ribbed V-belt must be replaced to continue driving. When the indicator appears, "STOP, ENGINE OFF!" (STOP, TURN OFF THE ENGINE!) the engine must not be started. There is a risk of engine damage.
- 2 The coolant cooling fan is faulty. (Monitor the coolant temperature gauge (Section Dashboard).
Lighting

Line 1 | Line 2 | TO* |
| LOW BEAM, L LOW BEAM, LEFT | CHECK LAMP CHECK LAMP! | 2 |
| LOW BEAM, R | CHECK LAMP | 2 |
| TRAILER TURN SIGN, L | CHECK LAMP | 2 |
| TRAILER TURN SIGN, R | CHECK LAMP | 2 |
| TRAILER BRAKE LIGHT | CHECK LAMP | 2 |
| TRAILER FOG LAMPN, R | CHECK LAMP | 2 |
| TRAILER REVERSE LIGHT | CHECK LAMP | 2 |
| TRAILER TAIL LIGHT, L | CHECK LAMP | 2 |
| TRAILER TAIL LIGHT, R | CHECK LAMP | 2 |
| DISPLAY DEFECTIVE | VISIT WORKSHOP! | 2 |
| TURN SIGNAL, L | CHECK LAMP | 2 |
| TURN SIGNAL, R | CHECK LAMP | 2 |
| L. TURN SIG. RFLECTR | CHECK LAMP | 2 |
| R. TURN SIG. RFLECTR | CHECK LAMP | 2 |
| TURN SIGNAL, F.L. | CHECK LAMP | 2 |
| TURN SIGNAL, F.R. | CHECK LAMP | 2 |
| BRAKE LIGHT | VISIT WORKSHOP! | 2 |
| BRAKE LIGHT, L | CHECK LAMP | 2 |
| BRAKE LIGHT, R | CHECK LAMP | 2 |
| 3RD STOP-LAMP | CHECK LAMP | 2 |
| HIGH BEAM, L | CHECK LAMP | 2 |
| HIGH BEAM, R | CHECK LAMP | 2 |
| LICENSE PLATE, L. | CHECK LAMP | 2 |
| LICENSE PLATE, R. | CHECK LAMP | 2 |
|
| SWITCH OFF LIGHT | 1 |
| FRONT FOGLAMP, L. | CHECK LAMP | 2 |
| FRONT FOGLAMP, R. | CHECK LAMP | 2 |
| REAR FOGLAMP | CHECK LAMP | 2 |
| REVERSE LIGHT, L | CHECK LAMP | 2 |
| REVERSE LIGHT, R | CHECK LAMP | 2 |
| TAIL LIGHT, L. | CHECK LAMP | 2 |
| TAIL LIGHT, R. | CHECK LAMP | 2 |
| SIDELIGHT, L | CHECK LAMP | 2 |
| SIDELIGHT, R | CHECK LAMP | 2 |
* Category (see above).
¹ The brake light comes on late or constantly - contact a service station immediately!
² The brake lights are equipped with several LEDs. The warning indicator is only activated when all LEDs fail.
When certain incandescent lamps fail, other lamps are energized to replace them. (Replacing faulty incandescent lamps is discussed in Chapter On-board electrical equipment).
Light sensor

* Category (see above).
If the light sensor is faulty, the headlights are automatically turned on.
In the "Individual settings" system, the installation menu "HEADLAMP MODE" (HEADLIGHT SWITCHING) can be set to "MANUAL" (MANUAL CONTROL) (Chapter Multifunctional steering wheel, multi-information display). Switching the headlights on and off is then again possible using the light switch (Section Switches).
Air suspension

* Category (see above).
- 1 Stop the vehicle immediately. Do not turn off the engine. If the indicator does not go out after 5 minutes, arrange for the vehicle to be towed to a service station.
Attention! When the indication appears "AIR SPRING STOP, CAR TOO LOW!" (AIR SUSPENSION, STOP, INSUFFICIENT GROUND CLEARANCE) from a certain steering wheel angle onwards, free wheel movement is no longer ensured. If the steering wheel is turned too far, the fender is damaged.
- 2 The system's functionality is limited.
Attention! When the indication appears "AIR SPRING VISIT WORKSHOP" (AIR SUSPENSION, CONTACT YOUR SERVICE STATION) do not exceed the maximum speed of 80 km/h.
Engine oil level

*K Category (see above).
- 1 The engine oil level should be checked immediately (refer to the Engine Oil Level Warning Light section).
- 2 There is no oil in the engine. There is a risk of engine damage.
- 3 There is a risk of damage to the engine or catalytic converter. The engine oil level should be checked immediately (refer to the Engine Oil Level Warning Light section).
- 4 The engine oil level has dropped to a critical level. The level should be checked immediately (Engine oil level warning indicator - Section Multifunctional steering wheel, multi-information display and Chapter Routine maintenance) and perform a visual inspection for oil leaks. It is also possible that the engine oil contains water. Check the engine oil.
- 5 The measuring system is faulty.
Oil temperature (engine oil temperature)

* K Category (see above).
There is a risk of engine damage - shift to a higher gear or reduce speed.
Once operating temperature has been restored, the engine oil level should be checked immediately (Engine oil level warning indicator - refer to Section Multifunctional steering wheel, multi-information display).
Key

* K Category (see above).
System "SPEEDTRONIC" \tempostat

* K Category (see above).
(Full article available on the resource: MercedesMan.ru)
- 1 The system is faulty "Speedtronic" and tempostat.
Door

* K Category (see above).
Selector lever AT

The indication appears in cars with a smart card (kEYLESS-GO system).
Move the AT selector lever to position "P".
The indicator appears when the engine is off and the driver's door is opened, if the selector lever is not in the "P" position.
Water in the windshield washer reservoir

* K Category (see above).
(Adding water - refer to Section Checking fluid levels, leak control).
