Contents: Removal ↡ Installation ↡
Removal
1. Drain the coolant.
2. Remove the radiator grille and the decorative panel below the grille.
3. Disconnect the tubes from the air filter housing 3 (figure 3.30).
4. Loosen the clamps of the compressed air supply pipes 7 and 8 from the compressed air radiator 1.
5. Disconnect the connectors from the radiator 2.
6. Remove the bonnet lock from the front centre beam 13.
Installation
7. Installation is carried out in order; reverse removal.
[Material borrowed from an online resource: MERCEDESMAN]
Figure 3.30. Cooling system radiator: 1 - Compressed air radiator; 2 - Cooling system radiator; 3 - Air filter housing; 4, 9, 10, 11 - Cooling system pipes; 5 - Crankcase ventilation tube; 6 - Inlet pipe; 7, 8 - Compressed air supply pipes; 12 - Air filter check sensor wiring connector; 13 - Front center beam; 14 - Bolts; 15 - Nuts.