Contents: Removal ↡ Installation ↡
Removal
1. Drain the engine oil.
2. Disconnect the wiring connector 3; oil level sensor B14 (figure 3.27)
3. Disconnect the oil level sensor wire B14 from the pan 1. Replace the retainer 2.
4. Remove oil level sensor B14. Replace sealing ring 4.
Installation
5. Installation is carried out in the reverse order of removal. Correct the engine oil level.
Start the engine and check the oil pressure: at idle speed - 0.5 bar, at maximum speed - 2.5 bar.
Figure 3.27. Oil level sensor: 1 - Pallet; 2 - Retainer; 3 - Engine wiring connector; 4 - Sealing ring; B14 - Oil level sensor.