Contents: Removal ↡ Installation ↡
Removal
1. Remove the service cover.
2. Remove cover 1 from intake manifold 4 (figure 3.35).
3. Disconnect the wiring connector 2 from the compressed air pressure sensor B13
4. Unscrew the compressed air pressure sensor B13. Replace the sealing ring 3.
Installation
5. Installation is carried out in the reverse order of removal.
Figure 3.35. Compressed air pressure sensor: 1 - Lid; 2 - Wiring connector; 3 - Sealing ring; 4 - Intake manifold; B13 - Compressed air pressure sensor.