Contents: Removal ↡ Installation ↡
Removal
1. Remove the service cover.
2. Remove the engine trim panel 7 (figure 3.5).
3. Disconnect the crankcase ventilation pipe 4 from the cylinder head cover 5.
4. Remove the cylinder head cover 5. Replace the oil seal 2 and gasket 6 of the cylinder head cover. Check gasket 3 between the cylinder head cover and the intake manifold and replace it if necessary.
Installation
5. Installation is carried out in the reverse order of removal.
Figure 3.5. Cylinder head cover: 1 - Bolt; 2 - Seal; 3.6- Gaskets; 4 - Crankcase ventilation tube; 5 - Cylinder head cover; 7 - Engine decorative panel.