Removal and installation the starter — removing and installing (Mercedes-Benz Sprinter 903)

Removal and installation of the starter must be carried out as follows:

• disconnect the negative terminal from the battery;
• disconnect the wire from the starter;
• unscrew the starter from the gearbox;
• remove the starter. It can be run next to the engine cross beam. To do this, turn the starter with the traction relay down a little, pull it out slightly and remove it to the side.

Installation is carried out in reverse order. Tighten the starter mounting bolts to a torque of 45 Nm, and the terminal nut to a torque of 25 Nm.