Contents: Removal ↡ Installation ↡
Removal
1. Disconnect the negative cable from the battery.
2. Reduce the pressure in the cooling system by opening the expansion tank cap.
3. Disconnect connector 1 from temperature sensor B60 (see figure 2.106). The location of the sensors is shown in the figure 2.107.
Figure 2.106. Removing the coolant temperature sensor:
1. Wiring connector,
B60. Temperature sensor.
Figure 2.107. Location of temperature sensors:
1. Temperature controller housing,
B1. Coolant temperature gauge temperature sensor,
B60. Engine control system temperature sensor.
4. Unscrew the temperature sensor B60. Replace the retainer if it is damaged.
5. Check the coolant level.
Installation
Installation is carried out in the reverse order of removal.