Contents: Removal ↡ Installation ↡
Removal
1. Turn off the ignition.
2. Drain the coolant.
3. Remove the upper cross member 1 (see figure 2.109).
Figure 2.109. Coolant level sensor:
1. Upper cross beam,
2. Expansion tank,
B7. Coolant level sensor,
B7.1. Coolant level sensor connector.
4. Disconnect the wiring connector B7.1 from the liquid level sensor B7.
(Original article is on the portal: «MercedesMan»)
5. Remove the liquid level sensor B7 from the expansion tank 2.
Installation
6. Installation is carried out in the reverse order of removal.