Removing
1. Disconnect the negative cable from the battery.
2. Remove the top cross beam.
3. Push radiator 1 forward (in the direction of travel) (see fig. 2.98).
Pic. 2.98. Fan:
1. Radiator,
2, 6. Nut,
3. Paddle wheel,
4. Locking washer,
5. Blocking disc,
M34. fan motor,
M34.3. Fan motor wiring connector.
4. Remove blocking disk 5 and nut 6, unscrew nut 6 or, if necessary, remove blocking washer 4.
5. Loosen the fan wheel 3 and remove it.
6. Loosen the M43.3 wiring connector and pull it out in the direction of the arrow.
7. Disconnect clamps (arrow) and remove the wire from the tie-down band.
8. Unscrew nuts 2 on the M34 fan motor and remove the motor together with the wire.
Installation
9. Installation is made in an order, the return to removal. Fasten nut 6 with blocking disk 5; check the installation of the locking washer 4.