VN 5.024 1. Bushing; 2. Wheel hub; 3. Bearing ring; 4. Retaining ring; 5. Brake disc protective plate; 6. Old bearing; 7. New bearing
Removal
- Remove the rear suspension arm.
- Disconnect the handbrake cable.
- Disconnect the rear speed sensor.
- Remove the bushing (1) (drawing VN 5.024).
- Clamp the rear suspension arm in a vice.
- Remove the hub (2).
- Clamp the hub (2) in a vice.
- Remove the inner bearing ring (3) from the hub using a puller.
Original article is on the portal www.mercedesman.ru
- Remove the retaining ring (4).
- Remove the protective plate (5) of the brake disc.
- Press out the outer ring (6) of the old bearing.
- Clean the bearing seat.
- Press in the new bearing ring.
- Then installation is carried out in the reverse order.