Contents: Removal ↡ Installation ↡
Removal
1. Unscrew nut 6 of the wheel hub and remove it (see figure 7.5).
Figure 7.5. Wheel hub:
1. Steering knuckle,
2. Ball bearing,
3. Retaining ring,
4. Wheel hub,
5. Half shaft,
6. Nut.
2. Remove the brake disc and disconnect the axle shaft,
3. Remove hub 4 from steering knuckle 1 using a punch.
4. Press the inner race of the ball bearing out of the hub.
5. Remove ball bearing 2 from the steering knuckle. Removed ball bearings cannot be used again and must be replaced with new ones.
Installation
6. Installation is carried out in the reverse order of removal.