Contents: Removal ↡ Installation ↡
Removal
1. Disconnect the negative cable from the battery.
2. Remove the air intakes.
3. Remove the windshield washer reservoir and disconnect the tubes.
4. Remove the cover from the wiring connector 4 and disconnect it from the ABS hydraulic unit 1 (see figure 9.25).
Figure 9.25. ABS/ABD or ABD/ETS hydraulic unit:
1. Hydraulic unit ABS/ABD or ABD/ETS,
2. Rubber supports,
3. Clamp.
4. Cork,
5. Ground connection wire.
5. Disconnect the ground wire 5 from the ABS hydraulic unit 1.
Original article is on the portal (MercedesMAN.ru)
6. Disconnect the pressure pipe from the ABS hydraulic unit 1.
7. Remove the ABS hydraulic unit 1 from the bracket on the body.
8. Remove the ABS/ABD or ABD/ETS control unit.
9. Check the delivery pipes, drain valves and all other components for leaks.
Installation
10. Installation is carried out in the reverse order of removal.