Contents: Removal ↡ Installation ↡
Removal
1. Remove the input shaft seal.
2. Remove the retaining ring 5 (figure 4.10).
3. Press out the primary shaft 7 in the direction of the retaining ring 8.
4. Remove retaining ring 8.
5. Press out ball bearing 6 of the primary shaft using a punch.
Installation
6. Installation is carried out in the reverse order of removal.
Figure 4.10. Primary shaft: 4 - Gearbox housing; 5, 8- Retaining rings; 6 - Ball bearing; 7 - Primary shaft.