Contents: Removal ↡ Installation ↡
Removal
1. Remove the clutch.
2. Remove ball bearing 3 together with retaining ring 4 (figure 2.52).
3. Remove bushing 2.
Figure 2.52. Crankshaft ball bearing: 1 - Flywheel; 2 - Bushing; 3 - Bearing; 4 - Closing ring.
Installation
4. Installation is carried out in the reverse order of removal. Using a punch, insert the bearing until it contacts the bushing. In many cases, it is possible to install the bearing by hand. After this, it is necessary to insert a new closing ring using a punch.
[Article text obtained from the website: Mercedesman.ru]