Contents: Removal ↡ Installation ↡
Removal
1. Disconnect connector 2 and remove bracket 3 (see figure 3.52).
Figure 3.52. Knock sensors:
1. Protective shield,
2, 10. Wiring connector,
3. Bracket,
4, 7, 12. Bolt,
5. Knock sensor 1,
6. Oil radiator,
8. Knock sensor 2,
9. Box with connectors,
11. Electrical wiring.
2. Remove the protective shield 1.
3. Unscrew bolt 4 and remove knock sensor 1 5.
4. Remove the cover of the connector box 9.
5. Disconnect wiring connector 10.
6. Disconnect wiring 11 from knock sensor 2 8. Do not damage the wiring. Replace the tie straps.
7. Remove the oil cooler 6.
8. Unscrew bolt 7 and remove knock sensor 2 8.
Installation
9. Installation is carried out in the reverse order of removal.