Contents: Removal ↡ Installation ↡
Removal
1. Drain the coolant.
2. Disconnect bracket 1 securing injector connector 2 (see figure 3.38).
Figure 3.38. Coolant temperature sensors:
1. Bracket,
2. Wiring connector,
3. Coolant temperature sensors,
4. Fixators,
5. Thermostat,
6. Seals,
7. Bolt.
3. Disconnect the connector from the coolant temperature sensors 3.
4. Remove the fasteners 4 securing the coolant temperature sensors 3 to the thermostat housing 5.
5. Remove the coolant temperature sensors 3.
Installation
6. Installation is carried out in the reverse order of removal. Replace seals 7.