Pic. 195. Removal and installation of the gear lever: 1 - protective cover of the lever; 2 - gearshift lever; 3 - hex bolt M10, 63 Nm; 4 - washer
The way of fastening of the switching lever is shown in fig. 195. When removing, you must perform the following operations:
- pull up the cover 1 lever (pic. 195);
- unscrew bolt 3 securing the lever to the gearbox rod and remove washer 4;
- pull up shift lever 2. In this case, do not use a hammer so as not to damage the internal parts of the lever;
- apply a little grease to the lever seat cone when installing. Tighten the lever mounting bolt to 63 Nm. Carefully fasten the protective cover.