Removing
1. Disconnect the negative cable from the battery.
2. Remove the right front wheel.
3. Disconnect the right half shaft (arrow) from the intermediate drive shaft (see fig.4.79).
Pic. 4.79. Generator:
1. D+ circuit wire,
2. B+ circuit wire,
3. Cover,
4. Bolt,
G1. Generator.
4. Loosen the alternator drive belt and remove it from the alternator pulley.
5. Loosen the tension rod on the arm and secure it to the side.
6. Remove cover 3.
7. Turn off bolts of fastening of wires 1 and 2 from the generator G1.
8. Disconnect the upper and lower compressed air pipes and fasten them to the side.
9. Turn off bolts 4. The top bolt is screwed in an alternator bracket.
10. Remove generator G1.
Installation
11. Installation is made in an order, the return to removal.