Sequence of works
Fig. 11.31. After the door seal (2) is removed at the handle level, access to its fastening bolt (1) with an internal Allen key will be opened
1. Remove the seal 2 (fig. 11.31) doors from the groove at the handle level.
2. Unscrew bolt 1 with internal hexagon SW 4 in the hole located under the handle.
3. Press the handle lock cylinder inward and pull it out from the outside.
4. Remove the door handle with the sealing gasket downwards from the support.
5. To facilitate reinstallation, completely unscrew the Phillips head eccentric bolt from the bottom hole.
Publication reprinted from this resource [MercedesMan.ru]
6. Install the handle first, then install the lock cylinder.
7. Tighten the Allen bolt SW 4.
8. Turn the Phillips-head eccentric bolt in the lower hole so that there is approximately 2 mm of play when opening.