Attention! It is recommended to drain the coolant from a cold engine. If this is not possible, place a piece of thick cloth over the filler cap of the radiator or expansion tank (depending on design), slowly turn the plug to the first stop and release the pressure. Reducing pressure can cause the coolant to boil, so take precautions to avoid burns if hot steam is released. Rotate the plug to the second stop and remove it.
1. Place a suitable container under the radiator.
2. Turn the heater control to the hot air position.
3. Using a screwdriver, unscrew the drain plug at the bottom of the radiator and drain the coolant. Install and tighten the plug after the liquid is completely drained.
4. Place a container under the right side of the cylinder block, unscrew the plug and drain the liquid from the block. Put the stopper in place.