Contents: Removal ↡ Installation ↡
Sequence of works
Removal
1. Remove the rear wiper arm as described previously.
[Full article available on the resource: Mercedesman.ru]
2. Open the trunk lid and remove the interior trim (see the "Body" section).
3. Disconnect the contact connector.
4. Disconnect the hose.
5. Unscrew the three screws securing the gear motor to the trunk lid and remove the gear motor assembly.
6. Check the rubber seal on the windshield wiper shaft in the trunk lid and replace it if necessary.
Installation
1. Check the seal in the trunk lid. Replace it if necessary, otherwise water will leak into the trunk.
2. Install the gear motor assembly.
3. Attach the washer hose.
4. Connect the plug connector.
5. Turn the windshield wiper on briefly and then turn it off again until it returns to its original (rest) position.
6. Install the wiper lever and bring it to the position marked on the glass with adhesive tape. When installing the lever, try not to touch the washer nozzle.
7. Put on the shaft axle nut and tighten. Put the cover on the nut.
8. Turn on the rear wiper and check the cleaning area. Adjust it if necessary.
9. Put on the inner lining of the trunk (see the "Body" section).