Removing
1. Turn off the ignition and remove the key from the lock.
2. Remove the glass cleaner brush holder.
3. Remove the overlay of the additional brake light, see relevant chapter.
4. Remove the upholstery of the tailgate, see relevant chapter.
5. Disconnect plug 1 power supply of the wiper motor.
6. Unscrew three bolts of fastening of the electric motor of a cleaner (see arrows in illustration) and remove the motor by pushing it down (see illustration).
Installation
7. Bolt the wiper motor to the rear door.
8. Connect the wiper motor power plug.
9. Turn on the electric motor and let it run for about a minute, and then turn it off with the switch under the steering wheel. This is necessary to set the motor to its original position.
10. Reinstall the tailgate trim.
11. Establish into place an overlay of an additional brake light.
12. Install the brush holder and check the operation of the glass cleaner.