Contents: Front ceiling light ↡ Rear ceiling light ↡
Sequence of works
Front ceiling light
1. Pry up the diffuser with a screwdriver.
Fig. 10.17. After removing the diffuser, the spotlight lamp can be replaced (arrows)
2. Remove the spotlight from the spring contacts (fig. 10.17). If necessary, carefully tighten the contacts.
Fig. 10.18. When reinstalling the lamp housing (1), first insert it from the windshield side and then lift it up until the spring clips (arrows) snap into place. First insert the connector (2) and check that it is working properly
3. Install the new lamp (fig. 10.18).
4. To remove the lamp, with the diffuser removed, pull back the clamps on both sides and pull out the lamp. Disconnect the wire from the back.
Rear ceiling light
Fig. 10.19. Replacing the lamp in the rear ceiling light
1. Carefully pry the lamp with a screwdriver and remove it from the hole in the ceiling (fig. 10.19).
2. Move the diffuser away.
3. Remove the spotlight from the spring contacts. If necessary, gently press the contacts.
4. Insert the new bulb.