Contents: Main salon light ↡ Front directional lights (reading…↡ Rear interior lights (models…↡ Rear directional lights (models…↡ Glove box light ↡
Main salon light
Replacing the main interior light bulb
1 - Ceiling lamp; 2 - Samples; 3 - Landing tabs; 4 - Guide grooves; N70 - Overhead console panel; N70e1 - Main interior light bulb
1. Using a screwdriver, pry through the notches (2) and release the mounting tabs (3) from the guide grooves (4), remove the lampshade (1) of the main interior light.
2. Using a clean, dry cloth, grasp the lamp (N70e1) and release it from the contact clamps.
3. Installation is carried out in the reverse order - make sure that the mounting tabs (3) of the lampshade (1) fit correctly into the guide grooves (4) of the console panel (N70).
Front directional lights (reading lamps)
Replacing the front directional light bulbs
1 - Cartridge; N70 - Overhead console panel
1. On models with the corresponding configuration (code ET2), activate the service mode of the TELE AID emergency call system (see Section Activation/deactivation of the service mode of the TELE AID emergency call system).
2. Turn on the auxiliary battery and connect it to the standard battery, then disconnect the negative cable from the latter.
7 - Auxiliary battery
8 — Positive wire terminal of the module
9 — Terminal of the negative wire of the module
W10 - Battery ground
3. Remove the overhead console panel (N70) (see Section Removal and installation the overhead console panel).
4. Turn in the direction indicated by the arrows and remove the socket (1) of the corresponding lamp.
5. Using a clean, dry cloth, grasp the lamp and release it from the contact clamps.
6. Installation is carried out in the reverse order - if the corresponding configuration (code ET2) deactivate the service mode of the TELE AID system, see Section Activation/deactivation of the service mode of the TELE AID emergency call system).
7. Finally, read the DTC codes and clear the on-board diagnostic system memory using the STAR DIAGNOSIS scanner (6511 1801 00) (See Chapter Engine electrical systems) and perform basic programming procedures.
Rear interior lights (models Universal)
Replacing the rear interior light bulb
2 - Connector; 3 - Lamp; E15/8 - Left rear interior light; E15/9 - Right rear interior light
1. Release the clips to release the rear light assembly (E15/8 or E15/9) from the ceiling trim panel.
2. Disconnect the electrical wiring connector (2).
3. Using a clean, dry cloth, grasp the lamp and release it from the contact clamps.
4. Installation is carried out in reverse order.
Rear directional lights (models Universal)
Replacing the rear directional light bulbs (E11/1 and E11/2)
1. Using a long wedge, carefully release the lamp (E11/1 or E11/2) from the ceiling trim panel, being careful not to damage the latter.
2. Using a clean, dry cloth, grasp the lamp and release it from the contact clamps.
3. Installation is carried out in reverse order.
Glove box light
Replacing the glove compartment light bulb (1)
1. Open the glove compartment lid and carefully release the flashlight from the clips.
2. Using a clean, dry cloth, grasp the lamp and release it from the contact clamps.
3. Installation is carried out in reverse order.