Contents: Mirror with manual adjustment ↡ Electrically operated mirror ↡ Mirror glass ↡ Mirror position adjustment motor ↡
Mirror with manual adjustment
1. Release the mirror adjustment handle mounting bracket and remove the handle.
2. From the inside of the door, remove the decorative mirror trim by detaching its upper part, then moving the trim up and removing it from the door.
3. Unscrew the screws and remove the rearview mirror from the door. Remove the rubber seal installed between the door and the mirror, check its condition and replace it if necessary.
4. Installation is performed in the reverse order of removal. If the mirror adjustment mechanism has play, eliminate it by tightening the screw located next to the adjustment handle.
Electrically operated mirror
Unscrewing the screw that secures the electrical connector of the mirror
Location of screws for mounting the outside rear view mirror
1. From the inside of the door, remove the decorative mirror trim by detaching its upper part, then moving the trim up and removing it from the door.
2. Unscrew the mounting screw and disconnect the electrical connector from the mirror (see fig. Unscrewing the screw securing the electrical connector of the mirror).
3. Unscrew the mounting screws and remove the mirror from the door (see Fig. Location of screws for fastening the outside rearview mirror). Remove the rubber seal located between the door and the mirror. Check its condition and replace it if necessary.
4. Installation is carried out in the reverse order of removal.
Mirror glass
Caution! The mirror glass is glued to the electric motor, so be careful when removing it so as not to break the glass.
1. Rotate the glass so that the inside of the glass enters the mirror housing as far as possible. Then insert a wide plastic or wooden wedge between the mirror glass and the plastic mirror housing. Carefully remove the mirror glass.
2. If equipped, disconnect the electrical connectors from the mirror heating element.
3. Connect the electrical connectors to the mirror heating element, then carefully install the mirror glass until it locks firmly into place.
Mirror position adjustment motor
1. Remove the mirror glass.
2. Remove the screws and the mirror adjustment motor and disconnect the electrical connector from it.
3. Connect the electrical connector to the motor and secure the motor with screws. Check the operation of the mirror adjustment motor, then install the mirror glass.