Upper group of switches
Under the central ventilation deflector there is a switch for the hazard warning lights, as well as switches for various purposes, such as seat heating, single lock, rear window wiper and stability control. The group of switches is replaced as a set if any element fails.
Removal
1. Disconnect the negative (-) battery cable with the ignition off. The cabin air filter box must be removed first.
Warning! Before disconnecting the cable, find out the radio receiver security code, if any, refer to Section Replacing the battery.
2. Remove the upper center console cover, refer to the relevant section.
3. Disconnect the switch group connector.
4. Remove the 6 mounting screws (arrows in the illustration) and disconnect the switch group from the back of the cover (1). (2) – cover holder.
Installation
1. Installation is performed in the reverse order of removal.
2. Connect the battery ground (-) cable with the ignition off. Reinstall the cabin air filter box. If necessary, enter the radio code and set the clock.
AT selector console
Depending on the equipment, the console is equipped with switches for seat heating and for the W/S driving programs.
Removal
1. Disconnect the negative (-) battery cable with the ignition off. The cabin air filter box must be removed first.
Warning! Before disconnecting the cable, find out the radio receiver security code, if any, refer to Section Replacing the battery.
2. Remove the shift selector knob as described in Section Removal and installation the center console.
3. Disconnect the connector (1) from the back of the casing frame from the switch strip (refer to the accompanying illustration).
4. Release the strips (3) and remove the switch strip from the holder.
Installation
1. Installation is performed in the reverse order of removal.
2. Connect the battery ground (-) cable with the ignition off. Reinstall the cabin air filter box. If necessary, enter the radio code and set the clock.