Upper group of switches/front door
In the group of switches next to the door handle, depending on the equipment, there is a switch for the electric seat and steering wheel adjustment.
Removing
1. Disconnect the negative cable (-) battery with the ignition off. The cabin air filter box must first be removed.
Attention! Before disconnecting the cable, find out the security code of the radio, if any, refer to Section Replacing the battery.
2. Remove facing on a forward door, address to the Section Removal and installation of a forward facing of a door.
3. Press out the locking bars with a screwdriver (arrows in the illustration) on the reverse side of the door trim and remove the switch group (1) from the door trim.
4. Disconnect the connector from the switch group.
Installation
1. Installation is carried out in the reverse order of removal.
2. Connect ground cable (-) battery with the ignition off. Install the cabin air filter box. If necessary, enter the radio code and set the time on the clock.
Lower group of switches/front door
In the group of switches, depending on the equipment, power window switches, child protection devices, as well as a switch for opening the trunk are installed.
Note. Removal and installation of the power window switch on the front passenger door is carried out in the same way.
Removing
1. Disconnect the negative cable (-) battery with the ignition off. The cabin air filter box must first be removed.
Attention! Before disconnecting the cable, find out the security code of the radio, if any, refer to Section Replacing the battery.
2. Remove facing on a forward door, address to the Section Removal and installation of a forward facing of a door.
3. Slide the lock from the back of the door trim (1) in the direction of the arrow (2). Disconnect the group of switches from the holder (3) and take out.
4. Disconnect the connector from the switch group.
Installation
1. Installation is carried out in the reverse order of removal.
2. Connect ground cable (-) battery with the ignition off. Install the cabin air filter box. If necessary, enter the radio code and set the time on the clock.
Power Window Switch/Rear Door
Removing
1. Disconnect the negative cable (-) battery with the ignition off. The cabin air filter box must first be removed.
Attention! Before disconnecting the cable, find out the security code of the radio, if any, refer to Section Replacing the battery.
2. Remove facing on a back door.
3. Disconnect the connector at the switch.
4. Disconnect the switch (1) on the reverse side of the door trim from the holder and remove.
Installation
1. Installation is carried out in the reverse order of removal.
2. Connect ground cable (-) battery with the ignition off. Install the cabin air filter box. If necessary, enter the radio code and set the time on the clock.