Disconnecting connectors and wiring from the center console | Removal of facing of the lever of a gear change from the central console |
1. Remove both front floor mats.
2. Remove the outdoor switches and covers by unscrewing the Phillips screws.
3. Remove the ashtray and frame, undock the wiring connectors.
4. Remove the floor carpet, remove the front screws securing the shift lever trim, lift the trim slightly and push out the signal light switch until the connector can be undocked.
5. Remove facing of the lever of a gear change from the central console.
6. Remove the radio.
7. Remove the heater control buttons and unscrew the nuts.
8. Remove the heater control knob and remove the cover. Disconnect the lighting wire.
9. Remove the screws from the front of the tunnel and the rear bolts from the center console. Also remove the screws from the ashtray.
10. Raise the rear of the center console and remove the console from the instrument panel, supporting the end of the console so that its edges do not separate.
11. Installation is made in an order, the return to removal.