Contents: Removal ↡ Installation ↡
Removal
1. Remove the protective strip (1) on the bumper, refer to Section Removal and installation the protective strip on the bumper.
2. Disconnect the connector at the sensor (2). At the same time, lift the locking bracket with a screwdriver.
3. Release the locking strips and remove the sensor from the holder (3).
Installation
1. Check the sealing ring (4) between the sensor and the protective strip. Replace if necessary.
2. Press the sensor into the holder and secure it.
3. Connect and secure the connector to the sensor.
4. Install the protective strip on the bumper, refer to Section Removal and installation the protective strip on the bumper.