Contents: Removal ↡ Installation ↡
Removal
1. Mark the position of the rear wheel relative to the hub with paint. This will allow you to install the balanced wheel in its original position during assembly. Loosen the wheel mounting bolts before jacking up the car. Raise the rear of the car, place it on stands and remove the rear wheel.
Attention! The operation of lifting and installing the car on stands is associated with danger! Therefore, before carrying out the operation, read the Section Jacking and towing Introduction to the manual.
2. Unscrew the plastic nuts and remove the expansion clamp (arrows in the illustration).
3. Remove the wing liner from the wheel arch.
Installation
1. Installation is performed in the reverse order of removal.
2. Install the rear wheel so that the marks made during removal match. Pre-lubricate the centering belt of the wheel disk on the hub with a thin layer of bearing grease. Do not lubricate the wheel mounting bolts. Replace rusty bolts. Tighten the bolts. Lower the car onto the wheels and tighten the bolts crosswise to 110 Nm.