Examination
1. Check gaps of doors with elements of a body. They must be uniform along the entire contour of the fit. The door must lie in the same plane with the wing or be no more than 1 mm deeper.
2. Check up a gap of a back door. The door must match the contour of the rear wing and the lower part of the sidewall or be no more than 1 mm deeper.
Adjustment
1. Fully lower the glass and open the door.
2. Turn out bolts of fastening (1) and remove the retainer.
3. Slightly unscrew the mounting bolts (1) door hinges at the top and bottom.
4. Close the door and adjust the gap by shifting the hinges.
5. Fasten the hinge bolts with a torque of 32Nm.
6. Attach the retainer without tightening it.
7. Close the door and adjust the position of the latch by moving it.
8. Fasten the retainer bolts with a torque of 28Nm.