Contents: Removal ↡ Installation ↡
Removal
1. Install the outside mirror inward.
2. Disconnect the negative (-) battery cable with the ignition off. The cabin air filter box must be removed first.
Warning! Before disconnecting the cable, find out the radio receiver security code, if any, refer to Section Replacing the battery.
3. Press the mirror inwards. To fix the mirror in this position, insert a wooden block (1) approximately 10 cm long and clamp it. (2) – outer mirror trim.
Note: On models with a power mirror, fold the mirror inward.
4. Remove the 3 mounting screws (3), remove the mirror from the door and pull the electrical wire out of the hole.
5. Disconnect the connector.
Installation
1. Place the mirror on the door and connect the connector.
(Full article available on the resource: MercedesMAN.ru)
2. Fix the mirror to the door with three screws and remove the wooden block.
3. Connect the negative (-) cable to the battery with the ignition off. Reinstall the cabin air filter box. Enter the radio code and set the clock.
4. Check the operation of the mirror and turn signal installation mechanism.