Contents: Removal ↡ Installation ↡
Removal
1. Disconnect the compressed air supply pipe from the mixing chamber 1 (see figure 5.56).
Figure 5.56. CDI fuel injection system coolant temperature sensor:
1. Mixing chamber,
2. Wiring connector,
3. Retaining ring,
B60. Coolant temperature sensor.
2. Disconnect the wiring connector 2 of the coolant temperature sensor B60.
3. Remove the radiator cap to relieve pressure in the system.
4. Remove the coolant temperature sensor B60. Using a screwdriver, press out the retaining ring 3.
Installation
5. Installation is carried out in the reverse order of removal. Replace the seal.