Contents: Removal ↡ Installation ↡
Removal
1. Remove the engine.
2. Drain the oil.
3. Remove the cooling system pipe 10 (see figure 2.78).
Figure 2.78. Pallet:
1. Oil level indicator guide tube,
2, 9. Bolt with gasket,
3. Lid,
4. Pallet gasket,
5. Pallet,
6, 7. Bolt,
8. Seal,
10. Cooling system pipe.
4. Remove the oil level indicator guide tube 1.
5. Remove the oil level sensor B9 (if it is installed).
6. Remove cover 3.
7. Remove pan 5 together with gasket 4.
Installation
8. Installation is carried out in the reverse order of removal. Wipe the sealing surfaces, replace gasket 4. Align the rear part 5 of the pan with the gearbox.
(Article obtained from this portal MercedesMAN)