Adjustment of the gear shift actuator located on the body floor tunnel
After removing the safety devices, hang the rods on the rocker shift levers.
Fix the position of the three levers at the bottom of the rocker mechanism by installing the fixing bolts.
Place the gear selector on the gearbox in neutral position.
Check the position of the levers on the gear shift cover and, if necessary, adjust the dimensions shown in fig. 174.
Adjust the length of the rods so that they fit without tension on the bolts of the levers of the rocker mechanism without shifting the levers on the cover of the gear mechanism.
Fix the fixing bolts on the rods and check the operation of the rocker mechanism.
Adjustment of the drive of a gear change located on a steering column
The adjustment is carried out in the same way as described above, the levers are located at the lower end of the gearshift shaft on the steering column. If the reversing lamps come on when engaging first and second gears, the reversing lamp switch o-ring must be replaced.