Removing
1. Disconnect the negative cable (-) battery with the ignition off. The cabin air filter box must first be removed.
Attention! Before disconnecting the cable, find out the security code of the radio, if any, refer to Section Replacing the battery.
2. Remove the front locker, refer to Section Removal and installation of the front wing locker.
3. Disconnect the fog lamp connector.
4. Driver's side: Turn the bulb holder counterclockwise and remove it.
5. Driver's side: Turn away bolts of fastening and remove a forward cover of the bottom of a body, address to the Section Removal and installation of a cover of an impellent compartment from the bottom.
6. Driver's side: Remove the screws, disconnect the bottom of the water tank and take it to the side, refer to Section Removal and installation of the water tank and pump motor.
7. Remove 2 screws (arrows in the illustration) headlight adjustment.
8. Take out the headlight (1).
Installation
1. Insert the fog lamp so that the guide pins fit into the bumper.
2. Fix the fog lamp with two screws.
3. Driver's side: Reinstall the washer reservoir, refer to Section Removal and installation of the water tank and pump motor.
4. Driver's side: Attach the underbody cover.
5. Driver's side: Insert bulb holder.
6. Dock the headlight connector.
7. Install the front locker, refer to Section Removal and installation of the front wing locker.
8. Connect ground cable (-) battery with the ignition off. Install the cabin air filter box. If necessary, enter the radio code and set the time on the clock.
9. Check the headlight range adjustment and, if necessary, adjust at the service station.