Contents: Removal ↡ Installation ↡
Removal
1. Disconnect the ground (-) wire terminal from the negative battery terminal, after turning off the ignition.
Warning! When you disconnect the battery from the radio, the security code is deleted, as well as all automatic settings on the radio station. If the code is unknown or not written down, then the radio can only be put into operation by resorting to the help of a workshop or the manufacturer of the radio. Therefore, make sure in advance that the code is known.
2. Remove the rear light bulb board, see the relevant chapter.
3. Unscrew the three nuts that secure the rear light diffuser (see arrows in the illustration).
Installation
4. Check the condition and replace the damaged or porous rubber gasket.
Article was obtained from the portal [Mercedesman.ru]
5. Put the headlight lens back in place and secure it with three nuts.
6. Replace the board with the bulbs.
7. Connect the negative (-) terminal of the battery, making sure that the ignition is off.
8. Enter the security code into the radio and set the clock.
9. Check the functionality of the headlight bulbs.