Check the reference position of the camshaft. The marks on the camshaft and the bearing cap must be aligned
Check the reference position of the camshaft. The marks on the camshaft and the bearing cap must be aligned
Checking the camshaft reference position (Mercedes-Benz S-Class W140)
Set the piston of the first cylinder to the TDC position.
Check the reference position of the camshaft. The marks on the camshaft and the bearing cap must be aligned
Check the reference position of the camshaft. The marks on the camshaft and the bearing cap must be aligned
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
The article has been verified: Polyakov Zakhar Grigorievich
More similar articles for repairing other models
☛ Camshaft Position Sensor — Removal and Installation Mercedes W168 (1997-2004)
☛ Camshaft, Tappet and Sprocket — Basics, Checking and Installation Mercedes 190 (W201) (1982-1993)
☛ Checking and adjusting the position of the camshafts Mercedes W124 (1984-1995)
☛ Checking and adjusting the basic position of the camshafts Mercedes W463 (1999-2019)
☛ Checking the balance shaft base position (112 series engines only) Mercedes W163 (1997-2005)
☛ Checking the relative position of the crankshaft and camshaft system Mercedes Vito 2 (2003-2014, diesel)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Introduction to guide
- User manual
- Maintenance
- Power unit
- Engine repair
- Cooling and heating systems
- Power and exhaust systems
- Ignition and control system
- Charge and launch systems
- Transmission
- Automatic gearbox
- Drive shafts
- Chassis
- Brake system
- Front suspension
- Rear suspension
- Steering
- Body
- Body elements
- Electrical equipment
- Equipment and devices
- Electrical circuits
- User manual
- Controls and instruments
- Driving and operation
- Maintenance
- Power unit
- Petrol engine V6
- Petrol engine V8
- Petrol engine V12
- Diesel engine OM603
- Diesel engine OM606
- Cooling system
- Power supply and injection system
- Control system HFM-SFI
- Control system LH-SFI
- Control systems ME-SFI
- Diesel control system
- Ignition system
- Charge and launch system
- Transmission
- Mechanical gearbox 717.438
- Mechanical gearbox 717.454
- Automatic gearbox 722.5
- Automatic gearbox 722.6
- Clutch and drive shafts
- Differential
- Chassis
- Brake system
- Steering
- Front suspension
- Rear suspension
- Body
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Electrical circuits
- General information
- Introduction to guide
- Power unit
- 8-cylinder V8 engine
- 6-cylinder I6 engine
- Cooling and lubrication system
- Power system (carburetor)
- Fuel injection system
- Ignition system
- Transmission
- Clutch and cardan
- Car gearbox
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Electrical equipment
- Power devices
- Electrical circuits