Removing
Front wheel hub installation details
5a - Pin; 9 - Hub; 9d - Nut; 9e - Hub cover; 9i - Bolt; 9m - Outer tapered roller bearing; 35 - Rear protective shield; 023 - Puller
1. Remove the front wheel.
2. Remove and check the brake disc.
3. Remove the cover (9e) hubs.
4. Loosen the bolt (9i), unscrew the nut (9d) and remove the outer tapered roller bearing (9m).
5. Remove the front wheel hub (9).
Examination
1. Check rear guard (35), replace if necessary.
2. Check the trunnion (5a) for wear on the bearing seats or the contact surface of the O-rings.
3. Check the tapered roller bearing, its rings and O-rings.
Installation
Installation is carried out in the reverse order of removal. The amount of lubricant for the hub: in the cap - 15 g, the total amount - 60 g.