Removing
1. Remove the heater control unit.
2. Disconnect the switch mounting bracket from the console.
3. Move the switch lever to the right, release it from its socket, then remove the switch block.
4. Disconnect the control cable from the base of the switch block and unscrew the mounting nuts.
5. Disconnect the electrical connector from the back of the switch block.
6. Remove the trim panel located under the glove box and the glove box.
7. Under the instrument panel, remove the control cables under the upper and lower flap levers.
Installation
1. Installation is made in sequence, return to removal. Adjust the switch by turning the switch to the 9 o'clock position and turning the adjusting nuts on the control cable connection at the rear of the switch until the bottom and top flaps are fully closed.