Pic. 7.23. Install the straight wheels and install the lock 1.
2. Check and adjust, if necessary, the position of the steering wheel in the center position. The steering gear must be set to the center position and markings must be made on the steering column and steering gear.
3. Install the tensioner 3 between the inner edges of the wheel disks (see fig.7.24).
Pic. 7.24. Install the tensioner 3 between the inner edges of the wheel disks.
4. Check and adjust if necessary the partial toe. To do this, loosen nut 4 on lever 5 and adjust the partial toe by turning lever 5 (see fig. 7.25). Protective covers must not be twisted.
Pic. 7.25. Convergence adjustment.
5. Check wheel alignment (under the weight of the car). The values of the angles of convergence of the front wheels are presented in table 7.4.
Table 7.4. The values of the angle of convergence of the front wheels.
6. Remove all installed accessories.