Front engine mount
Raise the front of the car.
Loosen the engine mounting bolts with a wrench from below.
Loosen the lower shock absorber mounting nut.
Attach the hoist cable to the engine and raise the engine slightly. You can put a jack with a wooden lining under the oil sump and raise the engine.
On fig. 52 shows one side of the front engine mount, with a heat shield mounted on the engine mount.
Pic. 52. Front engine mount.
1 - nut M8,
2 - shaped washer,
3 - rubber support,
4 - engine mounting bracket,
5 - engine shock absorber,
6 - shaped washer,
7 - rubber support,
8 - bracket,
9 - washer,
10 - bolt,
11 - nut,
12 - heat shield,
13 - combined bolt,
14 - engine support,
15 - bolt.
Installation is carried out in the reverse order.
Rear engine mount
On fig. 53 shows the rear cross member and rear suspension parts. To replace parts, the lower mudguard must be removed.
Pic. 53. Details of the rear engine mount. Length "L" and height "H" depend on the engine series.
1 - nut,
2 - spring washer,
3 - engine support,
4 - side support,
5 - cross member of the engine,
6 - washer,
7 - bolt with washer,
8 - washer,
9 - bolt with washer,
L - length, H - height.