Electrohydraulic control unit AT
2 - Gearbox; 3 - Pallet; 3a - Connector; 3b, 19a - Bolts; 4 - Drain plug; 5 - Oil filter; 19 - Electro-hydraulic control unit; 21 - Guide sleeve; 26 - 13-pin connector; 62 - Shield; a - Hole for speed sensor n3 (Y3/6/2); b - Hole for speed sensor n2 (Y3/6/2)
Removing
1. Set the gear selector lever to the position «R».
2. Remove the shield (62) and disconnect the 13-pin connector (26).
3. Loosen the guide bush (21) and remove it from the transmission.
4. Drain the transmission fluid by removing the plug (4).
5. Remove the pallet (3).
6. Remove the oil filter (5).
7. Turn away bolts (19a) and remove the electro-hydraulic block (19).
Installation
Installation is carried out in the reverse order of removal.