Contents: Removal ↡ Installation ↡
Removal
1. Disconnect the negative cable from the battery.
2. Remove the oil filler pipe (61) from the engine.
3. Remove the drain plug (4) from the transmission pan and drain the transmission oil.
4. Unscrew the drain plug (9) from the torque converter and drain the transmission oil.
5. Remove the shield (62) and disconnect the 13-pin connector (26).
6. Disconnect the parking lock activation cable (80).
7. Unscrew the bolts (95) securing the torque converter to the drive disk. Then remove the torque converter cover (81).
8. Unscrew the left and right oil lines (49) from the oil radiator.
9. Remove the gear shift rod (63) by disconnecting the retainer.
10. Remove the exhaust pipe mounting bracket (64).
11. Disconnect the exhaust system (94).
12. Remove the fan shroud from the radiator.
13. Unscrew the rear engine bracket with support (65).
14. Unscrew the cardan shaft (66).
15. Disconnect the ground wire (46) from the transmission.
16. Loosen the transmission mounting bolts to the cylinder block and remove it downwards at an angle.
17. Remove the torque converter.
Installation
Installation is carried out in the reverse order of removal.