Removal of the amplifier is performed in the following sequence:
Remove the master brake cylinder.
Disconnect the vacuum hose from the booster.
Remove the cover under the instrument panel and disconnect the push rod from the brake pedal.
Loosen the nuts securing the booster on the inside and remove the brake booster.
The amplifier is installed in the reverse order. Tighten the mounting nuts and tighten to a torque of 15...25 Nm.
Fig. 262. Removing the brake force booster.
1 - brake pedal,
2 - brake pedal pusher,
3 - bolt, nut and spring washer,
4 - brake force booster,
5 - sealing ring,
6 - master brake cylinder,
7 - nut,
8 - body panel,
9 - gasket,
10 - brake light switch,
11 - intermediate flange,
12 - spring,
13 - bracket.