Removing
1. Pull the lever (1) hood latch cable drive and disconnect the rear cable (2).
2. Remove the cover under the instrument panel, refer to the relevant section.
3. Open the hood and set it upright.
4. Remove the hood latch (3), refer to the relevant section.
5. Disconnect the front hood drive cable (4) at the castle.
6. Open the cover of the branch assembly (5) and disconnect the rear hood drive (2) from the branch node.
7. Release front drive hood (4) from clamp holders (6) and take out together with the branch unit (5) from the engine compartment.
Note. To remove the rear hood latch (2) first remove the fuse block in the engine compartment. Then take out the rubber seal (7) from the bulkhead of the engine compartment and, finally, remove the rear drive of the lock from the engine compartment.
Installation
Installation is carried out in the reverse order of removal.