Contents: Removal ↡ Installation ↡
4. Water collector; 5. Rubber wiper bearings; 6. Right mounting bolt; 8. Water drain hose; 10. Channel for pipelines
4. Water collector; 7. Air access device clamps; 9. Drain; 11. Middle part of the septum; 12. Clamp; 13. Bolt; 14. Spring clamp; 15. Control device support; 16. Hexagonal nut
Removal
1. Remove the cover under the windshield.
2. Remove the windshield wiper assembly.
3. Unscrew the two rubber supports (5).
4. Disconnect 4 clamps (7), unscrew one bolt (6).
5. Disconnect the wire channel (10).
6. Disconnect the fuel line clamp (12).
7. Remove 4 screws (13), press 2 spring clips and remove the middle part of the partition (11).
Attention! When installing the middle part of the partition in its original place, pay attention to the rubber tip for the heating supply hose.
8. Remove the control device support (15) by unscrewing the three nuts (16).
9. Remove the water collector.
Attention! When replacing the water collector, ensure that the drain and drain hose are in the correct position.
Installation
Installation is carried out in the reverse order of removal.
(Full article available on the resource: «mercedesman.ru»)